bare-ass cedar posts or logs add a hick gist in gardens , either as fencing or as moulding for raised bed . Cedar also hold out many types of fungus and insects , lasting for year without any chemical treatment . Removing the bark expeditiously depends on the right puppet and the right timing , since the bark skid easily in natural spring and other summer but locks tightly to the sapwood for the sleep of the year .

Step 1

Cut cedar tree trees for peeled logs too soon in the spring and influence them on the smear – the ready the better , since bark sets to the wood in only a few days .

Step 2

Set the cedar log or position on log sales booth , which can be simple short sections of rough log large enough to give a few inch of ground headway .

Step 3

Drive a logarithm frankfurter – which looks like a large metal staple fibre – into each remainder of the cedar tree post , with one prong of the log dogs in the post and the other prong in the log rack .

Step 4

stand up near the substance of the logarithm and look it . position the cutting end of the barque potato – an over - sized chisel with a handle about 4 foot long – bevel up on the center of the log with the edge of the spud parallel to the logarithm .

Step 5

Press closely directly down . Use your body weight to squeeze the fleck through the bark and to the sapwood – feel the crush when the bit breaks through .

Step 6

Reverse the bit of the spud in the same swing and press down again , this clock time with the bit bevel up . Lever the handle downward as you press the tater forward and the snatch slips under the bark .

Step 7

Work the snatch from side to side and open up the bark layer along the duration of the cedar log . bump the log click unaffixed to rotate the logarithm and insure it in a new position to get at the residual of the barque . disunited sections unaffixed with the spud if the loose bark gets in the direction .

Step 8

Clean up any pocket-size barque pockets with the draw knife or the niche of the spud .

Tip

To use true cedar barque for cordage without killing the tree , take a unbent section of trunk and make two horizontal cuts with a tongue at the bottom and top of the unflawed country . Pull away the out broken bark to get at the self-coloured tan layer beneath . crowbar a strip promiscuous with a tongue pourboire and pull it barren of the tree . Weave and splicing small strip together to make longsighted chain of rope .

Warning

Be very deliberate when working with a barque potato and do n’t put your foot in the way of the blade . Freshly peeled cedar is as glib as a legal community of scoop so gestate some sudden shifts in balance as you work .

Things Needed

References

…