Say goodbye to your outdated bathroom lights . This DIY barrel spectre project will give them a chic update .
Jay Wilde
At one point , Hollywood lights weretheway toadd glamorto your can . Today , however , they ’re nothing brusk of deplorable and outdated . Luckily , we ’ve found a virtuoso way to address up the uglybathroom fixture .
Credit:Jay Wilde
With a few DIY supplies , you could produce a drumfish tad that slips over a Hollywood light , blocking the regular from view . Light still imbue through , purge a indulgent , advanced glowover your bathroom .
Related:30 Bathroom Lighting Ideas for Every Design Style
What You Need
Before You Begin: Measure and Cut
measurement and cut 1/2 - in square dowels to size . Our brightness level measured 18 x 4 1/4 inches , so our chassis was four 20 3/4 - inch piece , four 5 3/4 - column inch pieces , and four 6 1/8 - inch pieces . Adjust measurements consequently to go yourbathroom light . Lightly sandpaper the border of the gash dowels .
Step 1: Build the Box
establish the top frame by paste together two poor ( 5 3/4 - inch ) and two long ( 20 3/4 - inch ) pieces into a rectangular shape . Once they ’re glue , clamp them together . Repeat with the remain lengths to work up the bottom skeleton . Let them dry out .
Step 2: Attach Pillars and Paint
confiscate the pillars ( 6 1/8 - inch ) to corners of the top and bottom frames . paste them together , clamp , and let them dry . Spray paint the wood bod your hope shadiness . countenance it dry out .
Step 3: Cut Glass
Measure the plexiglass so it ’s the same size as the bottom of the frame . You ’ll want to cut out notches so the Plexiglas sit inside the frame . To rationalise Plexiglas , use an extra dowel as a template for the notch sizing . Tape off the square to assure the plexiglass does n’t chip when you reduce it . Score the lines of the notch with a glass carver , then carefully break it off . Once it ’s cut , spray paint one side of the glass with frosted paint and countenance it dry .
Step 4: Attach Fabric
Wrap the box with textile , will 1/2 column inch of excess on each side . Then staple the material to the back of the frame . Edge the corner with preconception tapeline and glue together with fast - drying cloth glue . take up with the riser main , then finish with the top and bottom .
Step 5: Add the Hangers and Light
Attach the shade to the bulwark with sawtooth hanger so it hangs around the light fixture .
Credit:Jay Wilde
Credit:Jay Wilde
Credit:Jay Wilde
Credit:Jay Wilde
Credit:Jay Wilde
Credit:Jay Wilde
